Banner
Home > news > Content
Paper machinery equipment manufacturers to analyze the installation and commissioning of paper machine equipment
- 2018-07-05-

       I. Paper Machinery EquipmentPre-installation preparations:
       1. When the paper-making and paper-making machinery is transported to the site and not installed, keep it in a safe place. The exposed parts should be coated with anti-rust grease as much as possible. The surface wind and rain will prevent the group from rusting. To carry out, we must establish a maintenance system. 2. The plant and foundation should be of sufficient height and installation position according to the basic dimensions of the paper-making and paper-making machinery installation. The base of the paper-making and paper-making machinery should be made of high-standard cement and must be embedded with steel bars, and the threading pipe should be reserved. Cable trench.
       3, should be equipped with 1-2 tons of lifting tools for the installation and maintenance of burning paper and paper machinery.
       4, the paper-making machinery from the factory to the use of more than 6 months, must be a cleaning inspection of the equipment, after the cleaning inspection should be added to the various parts of the lubrication oil.
       II. Installation of paper machine equipment:
       Fixed, mainly to control a certain height, and then use the level plane end, at the same time, to say that the screws on the transmission equipment are fixed.
       2, paper machine equipment host installation please follow the steps we have specified.
       3. The position and telling of the steam pipe shall be installed according to the general plan, and shall not be modified or processed arbitrarily. The joints of the pipes shall be sealed, and there shall be no air leakage after tightening. Phenomenon, after the components are installed, the test machine should be carried out.
       Third, paper machine commissioning (idle test machine):
       1. Paper machine after installation The empty load test machine shall be carried out, and the time of the host idling test machine shall not be less than 1 hour; the main machine shall be operated smoothly to be slow to produce.
       2. All supporting equipment of papermaking machinery should also be turned on at no load, and then used after normal operation, and then observe its operation effect, no abnormal noise and vibration.
       3, the load operation test machine time is not less than 8 hours, after the paper machine works normally, the whole machine has no abnormal noise, and there is no air leakage at the connection of each pipe. After the test machine, tighten the pipe joint again and put it into normal use. Gas, air, heavy oil, petroleum, chemical and pharmaceuticals are all applicable.

Related News